Materials Managing Power UNIT

Materials Managing Energy UNIT one
Basic Description
This energy unit is intended for that fork lift sector, consisting of hugely effective gear pump, DC motor, manual increase and lower valve, tank, ect. The up and down movement are managed by the lever on the manual release valve, that is outfitted with an electrical switch to activate the motor. The lowing pace is controlled through the strain compensated flow handle valve.
Special Notes
1. The duty of this power unit is S3, i.e. 30 seconds on and 270 senconds off.
2. Clean every one of the hydraulic components concerned before installation of the energy unit.
3. Viscosity of your hydraulic oil shoud be 15~46 cst, which ought to also be clean and cost-free of impurities, N46 hydraulic oil is recommended .
4. Oil altering is required immediately after the original a hundred operation hrs, afterwards the moment every single 3000 hrs.
five. The power unit shown is created to be mounted horizontally.

Material Dealing with Electrical power UNIT two
Basic Description
This power unit attributes power up gravity down circuit. Activate the begin solenoid to start the motor to lift the machine. The lowing movement is activated by the solenoid valve using the reducing speed controlled from the pressure compensated flow control valve. Items of this series can be broadly utilized in the market of logistic devices for example fork lift, mini lift table, and so on.
Special Notes
1. The duty of this energy unit is MATERIAL%20HANDLING%20POWER%20UNIT%201S3,i.e.,30 seconds on and 270 senconds off.
2. Clean all the hydraulic parts concerned just before mounting the electrical power unit.
three. Viscosity on the hydraulic oil shoud be 15~46 cst,which should really also be clean and free of charge of impurities, N46 hydraulic oil is proposed .
4. Oil modifying is required following the initial one hundred operation hours,afterwards the moment each and every 3000 hrs.
five. The electrical power unit should be mounted horizontally.

Share your love