FHDFS Type Floating Shaft Couplings
The FHDFS Type coupling includes two flex-rigid couplings and 1 floating shaft. The coupling is provided with all the rigid hubs outboard unless of course otherwise specified. The coupling comes with exposed bolts only.
Options
Flex Hubs for lengthy life
Conventional 20° pressure angle
Heat handled bolts for greater strength
Corrosion resistant bolts and nuts for ease of servicing
Accommodates parallel and angular misalignment
Elimination of center assembly permits forease of upkeep devoid of repositioning machinery
Rigid hubs outboard enables for greater shaft diameters
Developed for high-torque low-speed applications that arise in mill operations
Ordering Information
Application: Driver and Driven.
Kind and size of coupling, horizontal, vertical etc.
Electrical power: Motor horspower or torque requirement.
Speed: Motor RPM or Driven RPM.
Distance amongst shaft ends (BSE).
Connecting gear shaft sizes.
Specify which hubs are for being applied about the products (Rigid or Flex).
Rigid hubs will be used about the tools except if otherwise specified.
Length of floating shaft might have an impact on max angular misalignment.

FMM Style Mill Couplings
The FMM Variety coupling includes one particular normal flex hub, a single universal straight bored hub as conventional, FMM%20Type%20Mill%20Couplingstwo sleeves and one accessory kit. This coupling is supplied with exposed bolts as typical. Shrouded bolts are available upon request by size 5.five.
Attributes
For extended lifestyle
Normal 20° strain angle
Heat handled bolts for better power
Corrosion resistant bolts and nuts for ease of servicing
Presents parallel, angular misalignment and end float
Flex Half coupling interchangeable with marketplace standards
Long Universal Hub provided to customer specs with straight or tapered bores
Ordering Facts
Application: Driver and Driven.
Kind and dimension of coupling, horizontal, vertical etc.
Energy: Motor horspower or torque necessity.
Speed: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Shaft sizes.
Taper per foot and length of taper if tapered bore is needed.
Specify counterbore dimensions if desired.
Submit a drawing if accessible.