Power UNITS FOR LIFT TABLE 1
General Description
This energy unit is created exclusively for the modest lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has become broadly used within the market of logistic products which include minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled through the solenoid valve with the pace managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Common Description
This energy unit is made solely to the medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve and also the speed managed from the adjustable needle valve. Once the lift rises to a large positoin, however the power supply is minimize, the reducing motion is managed from the guide override perform.
Power UNITS FOR LIFT TABLE 3
Basic Description
This energy unit is developed solely for the large lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve as well as the velocity controlled by a stress compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE 4
Basic Description
This power unit is designed solely for the huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve along POWER%20UNITS%20FOR%20LIFT%20TABLE%202with the pace controlled by the adjustable needle valve. Once the lift rises to a high positoin, but the power supply is cut, the decreasing motion is managed through the manual override function.
Specific Notes
one. This power unit is of S3 duty cycle, which might only operate intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean the many hydraulic parts concerned prior to set up of the energy unit.
3. Viscosity with the oil shoud be 15~46 cst,which should really also be clean and totally free of impurities.N46 hydraulic oil is encouraged.
four. Oil changing is required immediately after the initial one hundred operation hours,afterwards once every 3000 hours.
five. The energy unit proven is created to be mounted vertically.