TF Form Flanges
Model TF flanges are made from the same high-strength cast iron as the S flanges, but are built to accommodate the international regular Taper Lock bushing for effortless installation and elimination
TF Variety flanges enable for mounting the bushing to the front (hub) side of your flange
TF flanges are available in sizes six by way of sixteen and will be made use of with any type of sleeve as pictured on webpage SF-5
TR Type Flanges
TR flanges are equivalent to your TF design, but enable for the Taper Lock Bushing to become mounted and removed from
the reverse or serration side from the flange
The restricted torque ratings of the Taper Lock Bushings make it possible for TR flanges to only be used with EPDM or Neoprene sleeves
Unique bushing sizes are made use of, so they've got various optimum bores than the TF flanges
Sizes 6 by sixteen can be found
Taper-Lock Bushings
The sector standard taper lock bushing is really a split layout allowing a compression fit on the flange on the shaft without set screws
The straightforward design can make the installation and elimination uncomplicated whilst the 8° taper grips tight and presents superb concentricity
A Reduced level of stock can be accomplished because of the numerous other energy transmission parts that use 
Taper Lock Bushings including: sheaves, sprockets, and pulleys
won't present the Taper-Lock Bushings themselves as they are broadly accessible from other manufacturers
