SMR Gearbox Installation
Satisfactory performance relies on right set up. lubrication and upkeep. thus it is necessary that the instructions in the set up and upkeep leaflet. provided with every single gearbox. are followed cautiously. several of the important elements of belt and torque-arm set up are listed below.
1. Install pulley on gearbox input shaft as near to your reducer feasible, and mount reducer on driven shaft as shut to bearing as 
sensible. failure to complete this can lead to excess loads from the input shaft bearings and output bearings and could cause their premature failure.
two. Install motor and wedge belt drive together with the belt pull at around 90° to your center line between driven and input shafts. this will permit tensioning from the wedge belt drive together with the torque arm which ought to ideally be in tension. if output hub runs anti-clockwise. torque arm needs to be positioned the best.
three. lnstall torque-arm fulcrum on a rigid assistance to ensure that the torque-arm is going to be at approximately ideal angles for the center line with the driven shaft and also the torque arm situation bolt. ensure that there may be enough take up inside the turnbuckle for belt tension adjustment.
Preserve near.
Bell drive may very well be located in any handy postion. if your torque arm is to be used to tighten the belts, the drive needs to be at about tight angle for the line among the input and output shafts.
Bell drive might be found to the ideal if wanted.
If output hub rotates clock-wise. position belt drive and torque arm in opposite path to that proven within the illustration.
Torque arm and belt consider up.
Torque arm could possibly be mounted for the correct if preferred.
