Observing a couple of guidelines for accurate installation is vital towards the reputable and good operation with the gearbox or gear motor.
The principles set out listed here are meant being a preliminary guide to picking out gearbox or gear motor. For efficient and correct installation, stick to the guidelines provided within the installation, make use of the maintenances guide to the gearbox available from our revenue department.
Following is a short outline of set up 
guidelines:
a) Fastening:
Place gearbox on the surface giving ample rigidity. Mating surfaces should be machined and flat.
Mating surfaces need to be inside definite geometric tolerances (see guide). This can be primarily correct of flange-mounted gearboxes with splined hollow shafts.
In applications that involve substantial radial loads with the output end, flange mounting is proposed for some gearbox sizes as this mounting tends to make utilization of the double pilot diameters supplied in these gearboxes.
Make certain the gearbox is suitable for that needed mounting position.
Use screws of resistance class eight.8 and more than to secure the gearbox. Torque up screws to the figures
indicated from the pertinent tables.
With transmitted output torque greater than or equal 70% in the indicated M2max torque, and with
regular movement reversals, use screws with minimal resistance ten.9.
Some gearbox sizes is often fastened working with either screws or pins. Of pin seated in the frame the gearboxes be at least one.5 times pin diameter.
b) Connections
Safe the connection parts to gearbox input and output. Tend not to tap them with hammers or related resources.
To insert these elements, utilize the service screws and threaded holes offered about the shafts. You’ll want to clean off any grease or protects through the shafts in advance of fitting any connection components.
Fitting hydraulic motors.
Be cautious the O ring between motor flange and gearbox input flange when assembling. Install the
hydraulic motor in advance of filling lube oil to the gearbox.
Connecting the hydraulic brake.
The hydraulic circuit must be such to make sure that brake is released instants prior to gearbox begins and applied just after gearbox has stopped. Check that strain during the hydraulic line for brake release is at zero when gearbox is stopped.
Direction of rotation
Motors are connected towards the suitable electrical or hydraulic circuit as outlined by their course of rotation.
When executing these connections, bear in mind that all gearboxes, whether or not while in the in-line or right angle style, have the very same direction of rotation each at input and output. For more facts in the connection of electrical and hydraulic motors, see appropriate sections in this catalogue.
