one.A connecting link of an O-ring Chain for basic application is pre-coated with grease with the pins. Ahead of connection, confirm the grease over the surfaces of pins, and in the event the volume of grease is little, apply grease with bare hands. (If gloves are used, the grease will be absorbed by the gloves.)
Instance: Once the connecting link (I) of an O-ring chain for general application is
shipped, O-rings are fitted at the roots with the pins. In case the O-rings come loose due to vibration throughout transport, refit the O-rings in to your roots from the pins.
In this case, make sure you return the grease collected in the roots of your pins to the central surfaces of the pins, more at portion A than at portions B shown while in the over illustration. (Portions A is worn as a consequence of sliding using the bushings.)
two.The chain might be most conveniently connected on the teeth of the sprocket. Engage the hyperlinks at the two ends on the chain using the sprocket teeth and match connecting pins. Should the sprocket could be moved, the chain may also be linked around the loosened side.
3. Connecting method
1.Verify that O-rings are connected to the roots from the pins.
two.If the quantity of grease applied about the connecting pins is compact, coat the pins with grease in the central portions.
three.Insert the connecting pins into the bushings of your inner hyperlinks at the two ends.
4.Confirm that the grease is applied towards the complete encounter from the O-ring, and fit the O-ring onto the connecting pins.
5.Insert the connecting pins in to the connecting plate and while pressing the connecting plate, set up the spring clip. Confirm no matter whether the head (the end without a split) on the spring clip is turned from the feeding route from the chain. (See the following illustration.)
6.Be sure to confirm the spring clip is securely fitted in the clip grooves of the connecting pins.
This completes jointing in the connecting website link. Note that grease over the surfaces of connecting pins and O-rings may be removed during set up perform. In this case, re-grease employing 
the grease about the surface from the base chain or the grease inside the polyethylene bag in which the connecting link was contained.
